So...you built your coilover setup.

Maybe you used HTS and cut your strut casings 40mm and find that the car is too low.

Or you purchased a car that had some TRD springs that have had a coil cut one too many.

Or you've changed your wheel and tire combo and you are now rubbing too much.

Or you want to do some rally-X and need just a bit more clearance.

 How do you get some height back into the car without completely re-doing the suspension?

That is where our Riser Plates for the front come into play.

These are 1/2" tall (about 12mm) and fit directly on top of the camber plates or factory rubber upper strut mounts and raise the car by that 1/2"

These come in a pair and come with an assortment of hardware to mate them to nearly all camber plates and factory strut mounts.

Machined from solid aluminum and anodized clear for corrosion resistance and that NASA look!

Camber Plates are not included.